Campbell scientific cr1000 manual
The AM16/32 RELAY MULTIPLEXER is warranted by CAMPBELL SCIENTIFIC, INC. to be free from defects in materials and workmanship under datalogger manual. As purchased, the AM16/32 is intended for use in indoor, non-condensing enclosure is recommended. Compatibility The AM16/32 is compatible with Campbell’s CR, CR, CR23X, CR Warranty and Assistance The CR MEASUREMENT AND CONTROL SYSTEM is warranted by CAMPBELL SCIENTIFIC, INC. to be free from defects in materials and workmanship under normal use and service for thirty-six (36) months from. There is not a CRKD Operator's Manual. Operation of the CRKD is described in the CR and CR datalogger www.doorway.ruions: x x cm ( x x in.).
The CR MEASUREMENT AND CONTROL SYSTEM is warranted by CAMPBELL SCIENTIFIC, INC. to be free from defects in materials and workmanship under normal use and service for thirty-six (36) months from date of shipment unless specified otherwise. Batteries have no warranty. Campbell Scientific applications engineer for assistance in measuring unfamiliar sensors. CR Wiring Panel The wiring panel of the CR is the interface to many CR functions. These functions are best introduced by reviewing features of the CR wiring panel. card for removal before switching off the CR power. OV CS I/O All Campbell Scientific communication peripherals connect to the CR through the 9-pin subminiature D-type socket connector located on the front of the Wiring Panel labeled "CS I/O" (Figure OV). Table OV gives a brief description of each pin. TABLE OV
About this manual. Please note that this manual was originally produced by Campbell Scientific Inc. (CSI) primarily. for the US market. Some spellings, weights and measures may reflect this origin. Some useful conversion factors: Area: 1 in2 (square inch) = mm2. Length: 1 in. (inch) = mm. 1 ft (foot) = mm. 1 yard = m. The CR's I/O ports can be paired as transmit and receive, allowing serial communications with serial sensors and devices. Measurement Control Peripherals. The CR is compatible with all of our CDMs (requires an SC-CPI), SDMs, multiplexers, vibrating-wire interfaces, terminal input modules, and relays. CAMPBELL SCIENTIFIC, INC. does not accept collect calls. The AM16/32 is compatible with Campbell’s CR, CR, CR23X, Refer to datalogger manual for.
0コメント