How to engage 4wd manual hubs

 · I have the front manual locking hubs. to my limited understanding of the 4WD system, this is how i engage 4wd mode. To engage 4WD: 1: I put vehicle in neutral and apply the parking brake. 2: Then I lock the Front Manual hubs 3: I depress the clutch and shift into High 4WD mode (the 4WD mode light in the dash lights up). Freewheeling hubs or locking hubs engage or disengage the front axle half shaft from the hub of the front wheels. This allows the 4WD to behave in the same fashion as a conventional two-wheel drive car with only the rear wheels being 'driven'. It is only when 4WD is selected and the hubs set in the 'locked' position that the vehicle operates as a four-wheel drive - with power being applied to all www.doorway.ruted Reading Time: 7 mins.  · Find a spot with loose gravel, grass, dirt, or sand. Don't make tight turns in 4wd on dry pavement. Turn hubs lock to lock ° start engine, MT in neutral or AT in park. Pull Tcase Jshift back 3" from 2Hi to 4Hi and look for green 4x4 dash light. Put MT in 1st or AT in D.

I thought I would do a video about auto vs manual auto locking hubs. The ford owners manual sucks. The only way to tell % sure if you have auto locking hu. Answers. Re: F 4X4 MANUAL HUBS WILL NOT ENGAGE ALSO HAVING. Im not sure if a f and a f have the exact steering column,but incase it is then check at the base of the column inside and you may see a triangler shape bracket that the shift cable connects to,there will be 2 torque screws holding the bracket to the column. You would engage the manual locking hubs for 4wd use. You should also drive it in Hi-Loc with the hubs engaged every so often to ensure that everything in the t-case gets lubricated. How to tell if you have a part time NP? Ensure the front manual hubs are unlocked, put the transfer case into Hi and then put the transmission into drive.

How To Replace Your Manual Locking Hubs in 8 Steps. Step 1. Use a 9/inch hex bit to remove the six socket-head hub screws that hold the OEM manual locking hub’s cap in place. Step 2: Remove the cap to expose the locking hub assembly. Step 3: Use the blade of a small screwdriver to lift up the exposed end of the spring-like retaining ring. To engage 4WD: 1: I put vehicle in neutral and apply the parking brake. 2: Then I lock the Front Manual hubs. 3: I depress the clutch and shift into High 4WD mode (the 4WD mode light in the dash lights up) 5: then i shift the tranny into 1st gear and go. (i can feel the "drag" of the 4WD) To Disengage 4WD: 1: I come to a stop, and put the. Once the hubs are engaged you can simply put the t-case in 4wd. Keep in mind that you do have a part-time case, you absolutely can NOT leave it in 4wd on dry pavement, it's only used when there is limited traction, i.e. in mud or on ice. Full-time cases can be run in 4wd all the time and usually have auto hubs.